Curtis ENABLE 40 - Manual (Page 37)

31 Curtis enAble ® 40-Series Manual, Rev. B
Multi-Function Input 2 menu can be used to inhibit one or both actuators, and
to set a corresponding speed limit. Multi-Function Input 2 is at Pin 6 on the
14-pin connector; see Figure 6, page 9.
5 — PROGRAMMABLE PARAMETERS: Multi-Function Input 2 Parameters
MULTI-FUNCTION INPUT 2 MENU
PARAMETER RANGE DESCRIPTION
Off / Seat 0–1 0 = Multi-Function Input 2 ignored.
1 = Inhibit and/or Speed Limit functions active, depending on whether
input is high or low (see next parameter).
Active Low On/Off When programmed On, the Inhibit and Speed Limit functions are
active when the switch is closed (pulled low to B-); when programmed
Off, these functions are active when the switch is open.
Charger inhibit On/Off Enables Input 2 to be used with an on-board charger. The charger will
pull the inhibit active during charging, which will inhibit drive, light the
charger and battery icons in the handcontrol display, and engage the
EM brake.
Halt Act 1 Dir- On/Off Actuator 1 will be halted in the negative direction.
Halt Act 1 Dir+ On/Off Actuator 1 will be halted in the positive direction.
Halt Act 2 Dir- On/Off Actuator 2 will be halted in the negative direction.
Halt Act 2 Dir+ On/Off Actuator 2 will be halted in the positive direction.
Speed Limit 0–100 % Sets the speed limit that will be in effect when Input 2 is active.