Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 44)

40
If using multiple Remote Sensors in one wine room continue to mount the remaining sensors
before installation of the sensor cover plates. When multiple sensors are used the sensor
jumper position must be adjusted in order for proper averaging of temperature and humidity
readings. See page 27 for jumper set up. 如果同一酒窖内使用多个传感器， 应先安装好其
它的传感器，然后再盖上遥控传感器的
盖子。使用多个传感器， （控制采用温湿平均值）,
跳线位置必须经过调整。请 参阅 27 页有关 跳线位置的设置。
Joining Communication Cable 连接通信电缆
Important
Wine Guardian cooling systems are supplied with 15 meters of 6 wire, Cat 3 twisted pair
communication cable with RJ11 type connectors. Caution must be taken when
connecting two lengths of communication cable (splicing) to ensure uniform wire color
before and after splice. An RJ11 Modular 6 wire STRAIGHT THROUGH type coupler
is the ONLY coupler approved for splicing Wine Guardian twisted pair communication
cable.
注意事项
酒卫设备配备有 15 米长的（CAT3）3 类，6 线双绞线通讯电缆， 接口为 RJ- 11。如需
延长两个通信电缆的长度， 拼接操作必须谨慎，确保拼接前后电线的颜色匹配。 使用
1 个 RJ11 接口，6 线双绞线通讯电缆必须使用直通型耦合器， 此方法是酒卫唯一批准
的通信接线方式。