Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 54)

50
Press the “Up” or “Down” arrow once to change
screen from alarm to normal Temperature and
Humidity indication.
THIS ALARM FORCES THE SYSTEM TO
SHUT DOWN. “!1” will remain on screen until the
High Pressure reset switch has been reset. See the
trouble shooting guide page 47 for “Instructions to
Reset High Pressure Switch”
按“向上”或“向下”箭头更改屏幕上
的从报警到正常温度和湿度指示。
此报警强制系统关闭。 “报警”将持续
在 屏幕上，直到高压复位开关已被复
位。请参阅故障排除指南第 47 页有关
“ 高压复位开关指令”。
Condensate Switch
Fault
!2 = CS (condensate
switch) fault
Press the “Up” or “Down” arrow once to change
screen from alarm to normal Temperature and
Humidity indication.
THIS ALARM FORCES THE SYSTEM TO
SHUT DOWN. The “!2” will remain on screen until
the CS (condensate switch) fault is resolved and
reset.
See the trouble shooting guide (page –TBD) for
“Instructions to reset condensate switch”
按“向上”或“向下”箭头更改屏幕上
的从报警到正常温度和湿度指示。
此报警强制系统关闭。 “报警”将持续
在 屏幕上，直到高压复位开关已被复
位。请参阅故障排除指南第 47 页有关
“ 高压复位开关指令”。
Open Fault
!1= High pressure
switch fault