CANOGA PERKINS 9145E Standard NID Software Version 1.0 - Manual (Page 31)

System Configuration 9145E NID Software User’s Manual
Security Configuration
21
The System Log contains the log of all enabled Trap events.
1. To configure Traps, select Trap Configuration (2) from the System Configuration menu. The Trap
Configuration menu (Figure 3-13) opens.
2. Select the number of the trap group to change and press Enter. Cycle through the Log Only, Send
Only, Both Log And Send, or Disabled parameters using the Space Bar.
The Master Trap Control setting will override all other trap settings. For example, if the Master Trap
Control is set to Log Only, rather than set to Both Log And Send (as shown), all the other traps will only
log alarm events, regardless of the individual trap settings. If the Master Trap Control is set to Log And
Send, the individual traps will perform according to their individual settings. Setting the Master Trap
Control setting to Disabled will disable all traps.
3. Press Enter to close the editing function and then press Esc to return to the System Configuration
menu.
NOTE: The setting of the Master Trap Control will override all other trap settings.
Figure 3-13 Trap Configuration Menu
3.3 Security Configuration
The 9145E can be configured for Strong passwords. Use the Security Configuration Menu to set or change
the Password Configuration and the Lockout/Logout Configuration. From the System Configuration menu
select Security Configuration (3). The Security Configuration menu (Figure 3-14) opens.
Canoga Perkins Corp. Ethernet Network Interface Device 21-APR-2009
Model 9145E-404-8-0 V01.00 F506 11:05:02
-----------------------------------TRAP CONFIGURATION--------------------------
1) Master Trap Control Log Only
2) User Port Link Traps Both Log And Send
3) Network Port Link Traps Both Log And Send
4) Remote Fault Traps Both Log And Send
5) Link Loss Forwarding Traps Both Log And Send
6) Cold Start Traps Both Log And Send
7) Authentication Traps Both Log And Send
8) Diagnostic Traps Both Log And Send
9) Entity Configuration Traps Both Log And Send
10) Fan/Power/Temperature Traps Both Log And Send
11) SFP Traps Both Log And Send
Select [1-11]:
------------------------------------Messages-----------------------------------