CANOGA PERKINS 9145E Standard NID Software Version 1.0 - Manual (Page 64)

9145E NID Software User’s Manual Port Information
Port Configuration
54
3. Remove outermost VLAN Tag? - Removes the outermost VLAN Tag from packets received on
the User or Network port. Takes no action on untagged packets. Yes removes outermost tag.
4. Add VLAN Tag B to Untagged Packets only? - Yes adds VLAN Tag B to all untagged packets
received on the User or Network port.
5. Add VLAN tag C to tagged packets only? - Yes adds VLAN Tag C to all tagged packets received
on the User or Network port.
6. Add VLAN Tag C to Tagged Packets only using P-Bits of outermost VLAN tag? - Yes adds
VLAN Tag C to all tagged packets received on the User or Network port, using the same priority bit
as the inner tag of the packets.
7. Tag A VLAN ID (0-4094) - Sets VLAN ID for Tag A. The ID range 0 - 4094 is valid.
8. Tag B VLAN ID (0-4094) - Sets VLAN ID for Tag B. The ID range 0 - 4094 is valid.
Priority (0 - 7) - Sets P-Bit of VLAN Tag B. Values of 0-7 are Valid.
9. Tag C VLAN ID (0-4094) - Sets VLAN ID for Tag C. ID setting of 0 - 4094 are valid.
Priority (0 - 7) - Sets P-Bit of VLAN Tag C. Values of 0-7 are Valid.
5.2.3.2 Port VLAN ID Translation Table
The 9145E has the ability to translate customer VLAN Tag IDs on Service frames. Use the Port
VLAN ID Translation Table to configure outgoing packets to receive a new tag based on the
current outermost tag. The tag is changed in both directions.
To Configure VLAN Translations, from the VLAN Configuration menu, select Port VLAN
Translation Table (2) and press Enter. The Port VLAN ID Translation Table (Figure 5-8) opens.
Enable VLAN Translation - - Type 1 and press Enter. Use the Space Bar to cycle between Yes and
No.
Add/Delete/Modify VLAN Translation - Type 2 and press Enter. Type in the In VLAN number and
press Enter. Then type in the Out VLAN number and press Enter. The In VLAN/Out VLAN number
combination will be added to the list on the screen, in numerical order.
Check If VLAN In Translation Table - Type 3 and press Enter. Type in the VLAN number. A
message will open at the bottom of the screen, saying either VLAN xx is not in the table or VLAN xx is
mapped to VLAN xx.
5.2.3.3 P-Bit Translation Table
The 9145E can change the P-Bit setting in VLAN ID tags on Service frames to change their
priority status in the network. To change incoming Priority Bit Translations, type 3 and press
Enter. The P-Bit Translation Table (Figure 5-9) opens.
1. To modify the P-Bit translation data, type the number of the P-Bit you wish to translate, from 1 to 8,
and press Enter. Enter the P-Bit value and press Enter. Use Tab to switch between ports. The P-
Bit will be changed on the ingress direction for the port. Press Enter to confirm changes. Press
Enter to confirm changes.
2. To Enable or Disable P-Bit translation, type 9, press Enter, and use the Space Bar to select
between Yes and No. Use Tab to switch between ports.