8 syslog client configuration, Syslog client configuration – CANOGA PERKINS 9145E Standard NID Software Version 1.0 User Manual
Page 41
System Configuration
9145E NID Software User’s Manual
SYSLOG Client Configuration
31
Figure 3-20 SNTP Client Configuration Screen
5.
SNTP Server IP Address - Two SNTP servers can be configured
•
IP Address: Set the address for the SNTP server. IP address 0.0.0.0 indicates no server.
•
Retries: How many times the 9145E tries to synchronize before trying the alternate server.
Range is 0 to 10
•
Timeout (seconds): Wait period between unsuccessful attempts. Range is 1 to 30
•
Priority: Set which server to contact first. Range is 1 to 255 with 1 the highest priority and 255
the lowest. If the priority is the same for the two servers, the 9145E alternates tries between
the servers.
When entries are completed, press Esc to return to the System Configuration menu.
3.8 SYSLOG Client Configuration
Use the SYSLOG Client Configuration screen to configure the 9145E to send log messages to a SYSLOG
Server. From the System Configuration menu, select SYSLOG Client Configuration (8) and press Enter.
The SYSLOG Client Configuration screen (Figure 3-21) opens.
On the SYSLOG Client Configuration screen, type the number of the SYSLOG setting to change and press
Enter. When entries are completed, press Esc to return to the System Configuration menu.
Canoga Perkins Corp. Ethernet Network Interface Device 21-APR-2009
Model 9145E-404-8-0 V01.00 F506 11:24:43
-------------------------SNTP CLIENT CONFIGURATION-----------------------------
1. SNTP Client UTC Offset (hours) : -8
2. SNTP Client Observe DST : Enabled
SNTP Client DST Starts At : 08/03/2009 02:00
SNTP Client DST Ends At : 01/11/2009 02:00
3. SNTP Client Sync Interval (minutes): 5
4. SNTP Client Delay Time (seconds) : 0
5. SNTP Server IP Address 1 : 172.16.1.10
SNTP Server Retries 1 : 3
SNTP Server Timeout 1 (seconds) : 5
SNTP Server Priority 1 : 1
6. SNTP Server IP Address 2 : 0.0.0.0
SNTP Server Retries 2 : 3
SNTP Server Timeout 2 (seconds) : 5
SNTP Server Priority 2 : 1
Select [1-6]:
------------------------------------Messages-----------------------------------