Continued), Super bass button (super bass), Equaiizer controls (graphic equalizer) – Panasonic SC-CH60 User Manual
Page 12: Volume level control (volume), Headphones jack (phones), G) remote control signal sensor (sensor), Input select buttons (tape, aux, cd, tuner), Front panel controls and functions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Front Panel Controls and Functions
(continued)
i
Amplifier section
Power “STANDBY c!)/ON” switch
(POWER, STANDBY c!)/ON)
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a smalt amount of
power.
® Super bass button (SUPER BASS)
Press to boost the low-frequency ranges.
® Equaiizer controls
(GRAPHIC EQUALIZER)
Use to adjust the equalization level.
These controls are for compensation of tonal quality. By sliding
the controls at each of the indicated frequencies in the "+"
direction, the tonal quality is increased, and by sliding them in
the direction, the tonal quality is decreased.
® Volume level control (VOLUME)
Turn to adjust the volume level.
When turning the control, the alpha-numeric display shows the
volume level.
Note that — dB is the lowest volume setting and 0 dB is the
highest.
® Headphones Jack (PHONES)
Plug headphones cord into this jack.
(g) Remote control signal sensor (SENSOR)
Receives the signals from the remote control.
(^ Input select buttons (TAPE, AUX, CD, TUNER)
Press to select the sound source.
@) Tape-to-tape recording speed selector
(EDITING SPEED)
Press to select the recording speed when a tape-to-tape record
ing is made.