Panasonic SC-CH60 - Manual (Page 43)

specify the tape length by one minute.
CD Press ▼ PRESET TUNING or PRESET TUNING A to
specify the desired time.
You can specify up to 90 minutes.
(D Prese MEMORY/TAPE LENGTH.
Press RECORD for recording side A.
1 . After ATLS is over, the cassette deck will automatically
advance the tape beyond the leader tape,
2. The CD changer will start the disc play and the edit-recording
will start.
The tracks assigned on tape side A
3. When the tracks specified on tape side A have been played
through, the CD changer will be automatically set to the
pause mode.
4. The tape will continue to advanoe (although no sound is
being recorded) to the end of the tape.
7
After recording side A, the deck will stop auto­
matically. Then press STOP/EJECT to turn over
the tape.
8 Press RECORD for recording side B.
A non-recorded passage of about 10 seconds will be automati­
cally created, and then the tracks reserved on tape side B will
start playing to be recorded.
Notes:
You can edit-record up to 20 tracks.
You cannot edit-record the tracks numbering higher than 20.
To cancel fit editing
Press STOP/EJECT on the cassette deck and the
stop button on the compact disc changer.
■STOP/A EJECT
and
Both deck and changer will stop.
Program recording from two or three discs
You can record your desired tracks in your desired sequence from
two or three discs.
Notes:
The continuity of sound will be interrupted when the tape reaches to
the end.
The display on this unit does not show the total time of the
programmed tracks.
We recommend that you calculate the required recording length and
use an adequate tape.
Steps 2 to 6 are available only from the remote control.
1
Prepare the deck for recording.
(Follow the procedures step 1 and 2 on page 36.)
2
Press CD PROGRAM.
3
Press DISC.
4
Press one of the numeric buttons (1-3) to
specify which disc contains the track you want
to record.
5
Press the numeric button to specify the tracks
you want to record in the desired sequence.
6
Repeat steps 3 to 5 as required.
7
Press RECORD on the deck.
Recording will automatically start.
43