Steffes 7140 - Manual (Page 2)

w The equipment described herein is intended for installation by a qualified
technician in compliance with applicable local, state, and national codes and
requirements.
w To insure proper installation and operation of this product, completely read all
instructions prior to attempting to assemble, install, operate, maintain or repair
this product. Upon unpacking of the system, inspect all parts for damage prior
to installation and start-up.
w This manual should be retained by the owner upon completion of the installa-
tion and made available to service personnel as required.
w Disclaimer: In compiling this manual, Steffes Corporation has used its best
judgement based upon information available, but disclaims any responsibility
or liability for any errors or miscalculations contained herein, or any revisions
hereof, or which result, in whole or in part, from the use of this manual or any
revisions hereof.
After the heating system is installed, Steffes disclaims any responsibility or
liability for mold/mildew growth and/or any damages caused by either. We
strongly recommend that the user follow the moisture, mold and mildew pre-
vention guidelines of the Environmental Protection Agency (EPA), available at
http://www.epa.gov.
IMPORTANT
For Customer Use
Please record your model and serial number below. This number is found on the identification label
located on the lower left side of the Comfort Plus Commercial Hydronic heating system. Retain this
information for future reference.
Model No. ________________________________________________________________________
Serial No. ________________________________________________________________________
RECOGNIZE THESE SYMBOLS AS SAFETY PRECAUTIONS
It is important, both for your personal safety and to avoid possible damage
to the equipment and your property, that you observe the safety instruc-
tions given following these symbols.