ChemoMetec SCC-100 - Manual (Page 29)

4 Installation and Start-up
17
4 Installation and Start-up
4.1 Power on, power off
The NucleoCounter is powered by a 12VDC external power supply. To connect the power
supply to the NucleoCounter, connect it to the DC socket (see Figure 7), and plug the
mains power cord of the power supply into a wall outlet.
Figure 7. Connecting the 12VDC power cord plug to the NucleoCounter
The NucleoCounter can now be turned on and off by pressing the “On/Off” button on
the front panel.
4.1.1 Starting up
Caution! During start-up the NucleoCounter performs a self-check.
Never insert or remove any cassette during the start-up.
During start-up a brief noise is heard as the actuator motor is activated for test
purposes. This is a part of a normal start-up procedure. While the NucleoCounter is
starting up the display shows for a few seconds instrument details as follows:
NucleoCounter
SCC-100
V4.xx 2005-MM-DD
S/N: 002-01
Figure 8. The start-up display