ChemoMetec SCC-100 - Manual (Page 35)

5 Operation of the NucleoCounter
23
5.5.1 Setting Date (F200) and Time (F201)
The functions, F200 (“F + 2 + 0 + 0 + ↵”) and F201 (“F + 2 + 0 + 1 + ↵”), are used to
set the time and the date, respectively. The date and time are used when a printer or a
PC is connected to the printer port. Please refer to Technical Note 001 (Part No. 994-
0014) with respect to setting and using the Time and Date features.
5.5.2 Reset Counter (F30)
The function, F30 (“F + 3 + 0 + ↵”), is used to reset the Counter. The Counter counts the
number of analysis performed by the instrument. This feature is used when a printer is
connected to the instrument. Please refer to Technical Note 001 (Part No. 994-0014)
with respect using this feature.
5.5.3 Display contrast (F220)
When typing “F + 2 + 2 + 0 + ↵” it is possible to adjust the contrast of the LCD display.
Use the “1” or “2” keys in order to increase or decrease the contrast of the LCD-display.
The default value is 4. Values in the range from 0-9 can be chosen. The display will be
updated with the current value, which is shown in the upper right hand corner of the
display.
Contrast? 4
1: Up
2: Down
↵ store
Figure 14. A new LCD-contrast value can now be chosen
Contrast? 6
1: Up
2: Down
↵ store
Figure 15. LCD-contrast value 6 is going to be chosen
Press “↵” to store the chosen value (or “Esc” to retain to the existing value).
If the value has been changed the new contrast will be remembered during the session.
When shutting down the NucleoCounter asks if the new value shall be saved as the new
constrast value. Press “↵” to save or “Esc” if the present default value should not be
overwritten.