ChemoMetec SCC-100 - Manual (Page 52)

9 Equipment and Accessories
40
For connection of a printer (Impact type CM no. 939-0003; thermo type CM type no.
939-0006) please refer to Technical Note 001 (Impact type CM no. 994-0013; thermo
type CM no. 994-0014).
The NucleoCounter is equipped with a printer output port. It is located just below the
USB connector on the rear side as apparent from Figure 32 and Figure 33
Figure 32 Location of the Printer output on
the NucleoCounter Figure 33 Connecting the Printer cable to the
NucleoCounter (lower connector).
Table 6 Description of the NucleoCounter Printer Output connector
Pin no Name Maximum Voltage level 6
1 7
2 Rx ±10 VDC
3 Tx ±10 VDC
Metal Enclosure DGND 0 VDC
2 1
3
Metal
Enclosure
Figure 34 Printer Output connector seen from the cable entry side.
6 In normal operation. Refers to DGND Metal Enclosure. Taken from the datasheet for
MAX202ECSE.
7 There is no signal connected to pin 1.