Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 14)

14 35% Extra 300 ARF Assembly Manual
 3. Cut excess rod long enough (1mm) that it is easy to
grab and pull out when needed for transportation. The tail
wheel bracket will stop the rod from backing out of the
hinges.
The picture below shows the rod when cut.
Tail Wheel Assembly Installation
Required Parts
Tail gear and screws Springs
T-bracket and screws
Required Tools and Adhesives
2.5mm and 7/64-inch ball driver
Blue threadlock
Felt-tipped pen
Thin CA Pin vise
 1. Mount the T-bracket so it is parallel to the rudder horn
bolt and mark using a felt-tipped pen.
 2. Using a pin vise, drill the marked spots.
 3. Mount the sheet metal screws provided and back them
out.
 4. To harden the wall, apply some thin CA into the holes.
Wait until CA is dry before installing the T-bracket.
 5. Apply threadlock to the tail gear bolts.