Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 18)

18 35% Extra 300 ARF Assembly Manual
 6. Install the wheel pants. The order of installation is:
bolts, lock washers then washers.
 7. The wheel needs to be in the center of the pant as in
the picture below. If the wheel is rubbing against the wheel
pant, make sure to correct this by loosening the wheel
collars and adjusting the wheel position.
 8. Once both wheel pants and wheels are assembled,
the gear should look like this.
 9. To install the landing gear to the fuselage, use a long
3mm ball driver and #9 socket. It is also helpful to have a
magnet to insert the landing gear bolt and washers from the
top of the fuselage into the plate. The picture below shows
the tools needed to install the landing gear.
 10. Use the long 3mm ball driver from the top and
socket from the bottom to tighten the landing gear to the
fuselage.
 11. Once the landing gear is secured, pull up the cuffs
until they touch the fuselage and mark the bottom of the
cuffs onto the landing gear with a felt-tipped pen.
 12. Apply Shoo Goo to and above the marked spots.