Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 25)

25 35% Extra 300 ARF Assembly Manual
 10. Cut and remove the bottom former of the cowl for
canister exits using a rotary tool and cutting wheel.
Tuned Pipe Installation
Required Parts
Pipe mounts Silicone tubing
Required Parts (not included)
MTW RE2 Pipe
50mm drop header, 11 1/2-inch for RE2 tuned pipe setup
Couplers
Clamps
Required Tools and Adhesives
Hobby knife Felt-tipped pen
30-minute epoxy Clamps
Vise grip Iron
Ruler 100-grit sandpaper
Masking tape Industrial lubricant
Acid brush Mixing cup and sticks
 1. Prepare the mount by passing the silicone tubing
through the holes starting from the middle and finishing in
the middle.
 2. Apply 4 pieces of masking tape along the edges of the
section needed to be opened for tuned pipe cooling.
 3. Cut along the masking tape and remove the covering.