Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 30)

30 35% Extra 300 ARF Assembly Manual
 5. Cut the opposite side of hook and loop to the ignition
module and glue to the engine box.
 6. Cut a piece from the hook and loop roll provided in the
kit and strap the ignition module in place.
 7. Apply a piece of masking tape to the bottom of the
ignition regulator.
 8. Glue a piece of industrial-strength hook and loop using
medium CA to the back of the regulator over the masking
tape.
 9. Apply some medium CA to the former where the
ignition regulator will be mounted and glue the opposite side
of the hook and loop.
 10. Mount the regulator.
 11. Ignition switch mount is already installed at the side
of the fuselage. Remove the covering where the ignition
switch will be mounted.