Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 17)

17 35% Extra 300 ARF Assembly Manual
Main Gear and Wheel Pants
Installation
Required Parts
Landing gear 5/32-inch axles (2)
Wheel collars (4) 4mm bolts (4)
Locknuts (4) 4-40 screws (4)
Lock washers (4) Washers (4)
Wheel pants (2) Wheels (2)
Required Tools and Adhesives
3mm ball driver 9mm socket
Crescent wrench 1/2-inch wrench
Threadlock Felt-tipped pen
Thin CA Shoo Goo
3/32-inch ball driver
 1. Locate all the hardware necessary to mount the wheels
and wheel pants. Gear is mounted swept forward.
 2. Pass the cuffs through the landing gear legs as pictured
below so it fits the contour of the fuselage. Try the cuff and
gear on the fuselage if in doubt about orientation.
 3. Install the axle using an 1/2-inch nut wrench and
crescent wrench.
 4. Each wheel axle has two flat spots. Install the wheel
using the two wheel collars provided; apply threadlock to the
setscrews and tighten them. The wheel needs to rotate freely
and be centered.
 5. Apply threadlock to the wheel pant screws.