Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 29)

29 35% Extra 300 ARF Assembly Manual
 5. Cut 3 pieces of hook and loop from the roll provided
in the kit.
 6. Make sure CA is dry, mount the batteries and strap
them in using the hook and loop. Receiver batteries are
located at the sides and ignition battery in the middle.
Ignition Module, Switch and Regulator
Installation
Required Parts
Fuselage
Required Parts (not included)
JR 5203 regulator Ignition Module
JR heavy-duty switch or similar
JR heavy-duty 6-inch extension
Required Tools and Adhesives
Medium CA 1/4-inch Du-Bro foam
Scissors
Adhesive-backed hook and loop
 1. Apply some pieces of masking tape to the back of the
ignition module.
 2. Apply some medium CA to the back of masking tape
and glue a piece of foam to the masking tape.
 3. Glue a piece of hook and loop using medium CA.
 4. Apply some medium CA to the engine box where the
ignition module will be glued.