Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 6)

6 35% Extra 300 ARF Assembly Manual
Additional Required Tools
Rotary too
Cut-off wheel
Sanding drum
Drill Epoxy brush
Felt-tipped pen Ruler
Hex wrench: 1.5mm, 3mm, 4mm, 4.5mm, 3/32-inch, 5/32-
inch Iron
Hobby knife with #11 blade Mixing cup
Mixing stick
Paper towel
Pencil Hemostat
Shoo Goo or Zap-A-Dap-A-Goo
Phillips screwdriver: #1, #2 Pin vise
Vise grip
Masking tape
Rubbing alcohol
Nut driver: 1/4-inch, 1/2-inch, 9mm
Heat gun
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
3/32-inch (2.5mm), 3/16-inch (5mm), 1/4-inch
(6.35mm)
Additional Required Adhesives
Medium CA (PAAPT02)
Thin CA (PAAPT08)
CA remover/debonder (PAAPT16)
CA accelerator (PAAPT15)
Blue Threadlock (PAAPT42)
30-Minute Epoxy, 8 oz (PAAPT39)
before Starting Assembly
Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect the
fuselage, wing panels, rudder and stabilizer for damage. If
you find any damaged or missing parts, contact the place of
purchase.
If you find any wrinkles in the covering, use a heat gun or
covering iron to remove them. Use caution while working
around areas where the colors overlap to prevent separating
the colors.
HAN100 – Heat Gun
HAN150 – Covering Glove
HAN101 – Sealing Iron
HAN141 – Sealing Iron Sock