Hangar 9 35% Extra 300 ARF (3 Boxes) - Manual (Page 28)

28 35% Extra 300 ARF Assembly Manual
Picture of the aft end of the tuned pipes in the tunnel.
Receiver and Ignition battery
Installation
Required Parts
Fuselage Hook and loop roll
Required Parts (not included)
(2) 4000mAh 2-cell Spektrum Li-Po
(1) 2000mAh 2-cell Spektrum Li-Po
Required Tools and Adhesives
Medium CA
Scissors
Adhesive-backed hook and loop
 1. Cover the back of the batteries with pieces of
masking tape as in the picture below.
 2. Apply some medium CA to the back of masking
tape and glue a piece of hook and loop to the masking tape.
 3. Cut 3 pieces of opposite side of the hook and loop that
are glued to the batteries.
 4. Using medium CA, glue the pieces of hook and loop to
the fuselage in the allocated battery place.