Hardy HI LPRE05 Shear Beams - Manual (Page 21)

OPERATION AND INSTALLATION MANUAL
Page 15
FIG. 17: ANCHOR BOLTS TEMPLATE
Step 3. Use wood or metal to create the templates.
The size of the template depends on the
size of the anchor bolts.
Step 4. Mark a point on on each template. Then,
using the I/I diagram, make another mark
on the template measuring from the thru
hole center points on the base plate.
Step 5. Drill the thru holes the same size as the
base plate thru holes at each of the marks
you made on the templates.
Step 6. On the vessel or structural support that
will rest on the load point assemblies,
measure from the point where you want to
position the center of the fixed-pin load
point assembly’s top plate to where you
want the centers of the top plates of the
other load point assemblies used in the
weighing system. As you mark each cen-
ter point location, check the typical mount-
ing arrangements for load point systems
above.
Step 7. Place the center of the Anchor Bolt pattern
at the exact centers as measured in Step 6.
You can use the templates to assist in
locating these center points.