Kenmore 385.160201 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bar Tacking
CD
Stitch seiector:
5
(D Stitch width:
2 to 6.5
(3) Stitch length:
0.5 to 1
(4) Needle thread tension:
2 to 6
(5) Presser foot A:
Zigzag foot
WIDTH ®
LENGTH
M
e
This is similar to a very short satin stitch, and is used to
reinforce points of strain such as corners, pockets and
straps of iingerie.
Sew four (4) to six (6) stitches.
(D
Bar tack
Embroidery
CD Stitch seiector:
5
@
Stitch width:
1 to 6.5
d) Stitch length:
Any
(D Needle thread tension:
2 to 6
(5) Feed dogs:
Dropped
Presser foot:
Remove
WIDTH ®
LENGTH
Drop the feed dogs, and then remove the foot holder.
Adjust stitch width as desired. Draw a design onto the
fabric with tailor’s chalk. Stretch the fabric between
embroidery hoops, and then place the fabric under the
needle.
Lower the presser foot lifter to engage the needle thread
tension. Holding the needle thread in your ieft hand, rotate
the handwheel counterclockwise for one complete turn.
Pul! the needle thread to draw the bobbin thread to the right
side of the fabric. At medium speed, stitch along the
marked outline, guiding the fabric carefully by hand. After
embroidery is completed, raise the feed dogs for normal
sewing.