Automatic buttonhole (continued) – Kenmore 385.16231 User Manual
Page 106
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Automatic Buttonhole (Continued)
0 Guide slot
d) Guide block
@ Buttonhole guide plate
@ Buttonhole template
(5) Catch
(6) Setting mark
@ Gear
(8) Base plate
® Lever
Select a buttonhole template (4), Pul! back the guide plate
catch (5), and slide the template into the guide plate (3) to
get the desired buttonhole. Release the catch to lock the
template into place. Insert the gear©of the base plate Into
the template guide slot®so that the guide b!ock(l)fits into
the center of the guide slot.
0 Needle thread
0 Bobbin thread
@ Buttonhole foot
@Gear
©Slot
©Starting point
Attach the buttonhole foot©. Adjust the position of the
gear© so it is aligned with the starting point of the
template©. The lever can be used to change gear
positions. Puli the bobbin thread up through the guide slot
of the buttonhole guide plate by turning the handwheel
counterclockwise while holding the needle thread. Place
the bobbin and needle threads to the left side of the guide
plate. Leave 3" to 4" (7.0 to 10.0 cm) of thread.
94