Kenmore 385.16231 - Manual (Page 18)

SECTION и. GETTING READY TO SEW
Connecting Machine to Power Supply
Ф Foot control plug
@ Machine plug
@ Power supply plug
Ф Power switch
® Power supply cord
© Foot control
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power
1, Turn off the power switch ф.
2. Insert the foot control plug Ф, machine plug Ф into the
machine,
3- Insert the power supply plug ® into the outlet,
4- Turn the power switch.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread fora few minutes. Wipe away any oil which may
appear
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle..
Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
“ When attaching or removing any parts
- When cleaning the machine.
^ Do not place anything on the foot control, when not
sewing.
Polarized piug
This appliance has a polarized piug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way If the plug
does not fit in the outlet, reverse the piug, if it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model 21316 or YC-485 is used with
Sewing Machine Model 385.16231XXX (XXX represents
numbers 000 through 999),.
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.