Kenmore 385.16231 - Manual (Page 68)

Ваг Tacking
0 stitch setector: 5
(D
Stitch width: 2 to 6,5
@ Stitch length: 0.5 to 1
@ Needie thread tension: 2 to 6
(5) Presser foot A: Zigzag foot
This is simiiar to a very short satin stitch, and is used to
reinforce points of strain such as corners, pockets and
straps of lingerie.
Sew four (4) to six (6) stitches.
0 Bar tack
Embroidery
0
stitch selector: 5
(DStitch width: 1 to 6.5
(3) Stitch length: Any
@ Needle thread tension; 2 to 6
(D
Feed dogs: Dropped
* Presserfoot: Remove
Drop the feed dogs, and then remove the foot holder.
Adjust stitch width as desired, Draw a design onto the
fabric with tailor’s chalk. Stretch the fabric between
embroidery hoops, and then place the fabric under the
needle.
Lower the presserfoot lifter to engage the needle thread
tension Holding the needie thread in your left hand, rotate
the handwheel counterclockwise for one complete turn.
Pull the needle thread to draw the bobbin thread to the right
(top) side of the fabric. At medium speed, stitch along the
marked outiine, guiding the fabric carefully by hand. After
embroidery is completed, raise the teed dogs for norma!
sewing.
56