Repeat step 1 for each vs1000 attached to the s, At the server console, enter the command to bin, Enter the load line, as described under creatin – Comtrol VS1100 Novell NetWare User Manual
Page 16: Bind the protocol stack to the lan card, as des, At the server console, enter load nwccon, Select configure netware connect, Select ports, Netware connect installation and configuration
16
NetWare Connect Installation and Configuration
Novell NetWare
2.
Repeat Step 1 for each VS1000 attached to the server.
3.
At the server console, enter the command to bind the protocol
stack to a LAN card that is configured to support the Ethernet II
Frame type. The syntax for this is as follows:
bind AIOVS1 {LAN board name}
For example, if the command to load the LAN card driver is:
load ETHER frame=ETHERNET_II slot=10001 name=FRED
Then the bind command would be:
bind AIOVS1 FRED
Since you are binding the protocol stack to the LAN card, enter this
command only once, after all VS1000 load commands are entered.
NetWare Connect Installation and Configuration
Follow these steps:
1.
Enter the load line, as described under Creating an AIOVS1 Load
Line.
2.
Repeat Step 1 for each VS1000 attached to the server.
3.
Bind the protocol stack to the LAN card, as described above.
4.
At the server console, enter load nwccon.
The NetWare Connect Options menu is displayed:
5.
Select Configure NetWare Connect.
The Configuration Options menu is displayed.
6.
Select Ports.