Select configure netware connect, Use the options on this menu to configure port, Press esc to back out to the netware connect o – Comtrol VS1100 Novell NetWare User Manual
Page 20: Select view netware connect status, Select display port status. the port status wi, Press esc to back out of the menu system and e, Using a text editor or install.nlm, edit the a
20
NetWare Connect Installation and Configuration
Novell NetWare
20. Select Configure NetWare Connect.
21. Use the options on this menu to configure Port Groups and Security
as needed. For more information, see the Novell documentation.
22. Press Esc to back out to the NetWare Connect Options menu.
23. Select View NetWare Connect Status.
The Status Options menu is displayed.
24. Select Display Port Status. The Port Status window displays:
If the status of all configured ports is “Waiting,” you have correctly
completed setup and configuration. At this point, the system is
ready for users to dial in and access the server.
25. Press Esc to back out of the menu system and exit nwccon.
26. Using a text editor or install.nlm, edit the autoexec.ncf file. Add the
following:
•
One load aiovs1 command line for each VS1000 installed. Use
the syntax described in Step 1 of this procedure.
•
After all load aiovs1 commands, one bind aiovs1 command line
to bind the protocol stack to the LAN board. Use the syntax
described in Step 3 of this procedure.
At this point, the VS1000/VS1100 units should be fully operational.
The changes you have made to autoexec.ncf enable the server to
automatically execute the load and bind commands the next time the
server is downed and restarted.