Comtrol VS1100 Novell NetWare - Manual (Page 38)

38 Troubleshooting
Novell NetWare
Commands and options are discussed in the following table.
Table 6. VS1TRACE Commands
Command Description
Change Enable/disable trace functions. After you select
this, you can select AIOVS1, VS1000, or Port.
AIOVS1
The AIOVS1 trace functions are shown with their
current states (enabled or disabled). Press Y to
toggle the state or N to leave it as-is.
VS1000
The list of installed VS1000s is shown. Select a
VS1000 by board number, or press A to select all.
After you do so the VS1000 trace functions and
their current states are listed. Press Y to toggle
the state, or N to leave it as-is. If you selected
“All,” this repeats until all traces for all VS1000
units have been reviewed.
Port
The list of installed boards and ports is shown.
Select a board number and port, or press A to
select all. After you do, the port trace functions
and their current states are listed. Press Y to
toggle the state, or N to leave it as-is. If you
selected “All,” this repeats until all traces for all
ports have been reviewed.
Display Display trace results. After you select this, you can
select AIOVS1, VS1000, or Port. As above, if you
select VS1000 or Port, you can select specific
VS1000 units/Ports or all VS1000 units/Ports.
After you make you selections, the trace results
are displayed.
Screen Toggle the Debug Screen (Comtrol VS Trace
Display) enabled/disabled.
Logfile Toggle the log file (vs1trace.log) enabled/disabled.
eXit Exit from vs1trace.