Comtrol VS1100 Novell NetWare - Manual (Page 36)

36 Troubleshooting
Novell NetWare
Command Description
Hotswap This lets you replace an existing and configured
VS1000 with an identical unit, without downing
the server or reconfiguring ports.
Before you begin: Shut off the existing VS1000,
connect all cables to the new VS1000, and power
up the new VS1000.
After you press H, the list of installed units is
displayed. Select the unit to swap out by board
number. The MAC address of the selected VS1000
is displayed. Confirm that this is the unit you
want to replace, type in the MAC address of the
new VS1000, and press Enter. The new VS1000
immediately replaces the old one.
Note: Do not add or remove VS1100 expansion
units while swapping VS1000 units. The unit
being swapped in must have the same number of
ports as the unit it is replacing.
Stats Display statistics for AIOVS1, VS1000, or ports.
After you select this, you can press A to show
AIOVS1 statistics, V to display VS1000 statistics,
or P to display port statistics.
AIOVS1
DO NOT USE. Reserved for development use only.
VS1000
For Technical Support use only. Use only when
told to do so by Comtrol Technical Support.
Port
Select a port to examine by number or press A to
view data for all ports. For each port chosen, the
following is displayed:
AIO receiveBytes=0, transmitBytes=0, txqPut=0,
txqGet=0, txqSize=8192, txqCount=0, rxqPut=0,
rxqGet=0, rxqSize=8192, rxqCount=0,
parityErrors=0, framingErrors=0,
overrunSoftware=0, overrunHardware=0
HDLC QOut.cnt=0, QOut.Size=2000, QIn.cnt=0,
QIn.Size=2000
aioDtest DO NOT USE. Reserved for development use only.
Flowctl DO NOT USE. Reserved for development use only.
eXit Exit from vs1man.
Table 5. VS1MAN Commands