Move the cursor to the interface name field and, Select the desired port by name and press enter, Set other parameters on the ppp call destinatio – Comtrol VS1100 Novell NetWare User Manual
Page 29: Select yes and press enter, If authentication is enabled, you must enter a, Repeat steps 2—10 to add more destinations as, From the internetworking configuration menu, se, Select aiovs1 and press enter. the miscellaneou, Press the ins key. the protocol command configu, Enter aiovs1 for the nlm name, and press enter
NIAS/MPR Installation and Configuration
29
Novell NetWare
5.
Move the cursor to the Interface Name field and press Enter.
The list of PPP Network Interfaces is displayed.
6.
Select the desired port by name and press Enter.
7.
Set other parameters on the PPP Call Destination Configuration
screen as needed. When you are done, press Esc to exit. You are
asked if you want to save your changes.
8.
Select Yes and press Enter.
9.
If authentication is enabled, you must enter a password in order to
save your changes.
The updated list of WAN Call Destinations is displayed.
10. Repeat steps 2—10 to add more destinations as needed, or press
Esc to exit to the Internetworking Configuration menu.
Configuring Protocols
Follow these steps to configure the protocols:
1.
From the Internetworking Configuration menu, select Protocols.
The Protocol Configuration window is displayed.
2.
Select AIOVS1 and press Enter. The Miscellaneous Protocol Load
Commands window is displayed.
3.
Press the Ins key. The Protocol Command Configuration window is
displayed.
4.
Enter AIOVS1 for the NLM Name, and press Enter.
5.
Press Esc to close this window because no parameters are needed.
You are asked if you want to save your changes.
6.
Select Yes and press Enter.