Comtrol VS1100 Novell NetWare - Manual (Page 32)

32 NIAS/MPR Installation and Configuration
Novell NetWare
Reinitializing the System
After you have finished configuring MPR for the VS1000, it is not
necessary to edit the autoexec.ncf file or down and restart the server.
Instead, select Reinitialize System from the Internetworking
Configuration menu.
When the system has completed the reinitialization process, you are
ready to begin normal operations.
Adding VS1000 Virtual Servers
To add VS1000 virtual servers to an existing and operating NIAS/
MPR system, follow these steps:
1. Connect the VS1000 unit to the Ethernet hub.
2. Switch the VS1000 on, and verify that it passes power-up
diagnostics.
3. Use the Boards option on the Internetworking Configuration menu
to add the new unit.
4. Use the Network Interfaces option to configure the new ports.
5. Use the Reinitialize System option to put the new configuration into
effect.
You are now ready to resume normal operations.
Adding VS1100 Expansion Units
To add VS1100 expansion units to an existing and operating NIAS/
MPR system, follow these steps:
1. Power off the VS1000 to which the VS1100 will be connected.
2. Connect the VS1100 to the VS1000, following the instructions in
the Installing the Hardware section.
3. Switch the VS1000 back on.
4. Use the Boards option on the Internetworking Configuration menu
to change the number of AIO ports on the host VS1000.
5. Use the Network Interfaces option to configure the new ports.
6. Use the Reinitialize System option to put the new configuration into
effect.
Note: This causes all VS1000 units on the server to reload VS-Link.
You are now ready to resume normal operations.