Comtrol VS1100 Novell NetWare - Manual (Page 35)

Troubleshooting 35
Novell NetWare
Commands and options are discussed in the following table.
Table 5. VS1MAN Commands
Command Description
stAte Check the state of the VS1000 or of one or more
ports. After you select this, you are asked to press
V to check VS1000 units or P to check ports.
VS1000
The list of installed VS1000 units is shown and
you can select a specific VS1000 by board number
or press A to check all VS1000 units. A state of
INIT is the first level and means the VS1000 is
configured but not loaded. A state of ACTIVE
means the VS1000 is loaded and running.
Port
The range of port numbers is displayed. Select a
specific port by port number or press A to check
all ports. For each port, the AIO state and line
signals (CD, DSR, CTS, etc.) are displayed.
Config Display the configuration of AIOVS1, VS1000, or
of one or all ports. After you select this, you are
asked to select the configuration to display.
AIOVS1
The number of VS1000 devices, number of ports,
vs1trace.log file descriptor, and looping and flow
control values are displayed.
VS1000
The list of installed VS1000 units is displayed.
You can select a specific VS1000 by board number
or press A to display all. For each VS1000 selected,
the MAC (network address) is displayed.
Port
The list of installed boards and ports is displayed.
You can select a specific port by number, or press
A to display all. For each port selected, the speed,
data bits, stop bits, parity, flow control status, and
device name is displayed.