Comtrol DM AIR - Manual (Page 18)

18 - DeviceMaster AIR User Guide: 2000365 Rev. C Hardware Installation and WLAN Configuration
1-Port Serial Device Server Connection
1-Port Serial Device
Server Connection Use the following procedure to connect cables to use the DeviceMaster AIR as a
wireless 1-port serial device server.
1. Reconnect the 4” Ethernet jumper cable between the WLAN and LAN port of
the DeviceMaster AIR.
2. Verify that the LEDs on the top of the unit are
lit.
Note: The Status LED flashes while booting
and it takes approximately 15 seconds
for the bootloader to complete the cycle.
See
LEDs on Page 60 for more
information.
3. Ping the IP address that you pinged in Step 9
in Configuring an IP Address (Static or
DHCP).
If the ping fails, re-connect the WLAN port to
the Ethernet network, open your web browser,
enter the IP address, and check other
configuration settings. See
Troubleshooting
WLAN Port Problems on Page 63 for
troubleshooting procedures.
4. Go to the appropriate discussion or document
to configure network information for the serial portion of the DeviceMaster
AIR depending on your serial port requirements:
• TCP/IP socket configuration only, see Network Configuration for the Serial
Portion on Page 27
• COM or tty port (also supports TCP/IP socket) configuration, use the
appropriate NS-Link User Guide to install the NS-Link device driver for
your operating system. See
Locating Software and Documentation on Page
8, to locate the appropriate device driver and User Guide.