Comtrol DM AIR - Manual (Page 62)

62 - DeviceMaster AIR User Guide: 2000365 Rev. C Hardware Specifications and Compliance Notices
Notices
Notices
Radio Frequency
Interference (RFI)
(FCC 15.105) This equipment has been tested and found to comply with the limits for Class A
digital devices pursuant to Part 15 of the FCC Rules.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Labeling
Requirements (FCC
15.19) This equipment complies with part 15 of FCC rules. Operation is subject to the
following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
Modifications (FCC
15.21) Changes or modifications to this equipment not expressly approved by Comtrol
Corporation may void the user's authority to operate this equipment.
Serial Cables (FCC
15.27) This equipment is certified for Class A operation when used with unshielded
cables on models with the RJ45 connectors and with shielded cables on all models
with DB9 connectors.
Underwriters
Laboratory This equipment is Underwriters Laboratory “UL” listed.
Important Safety
Information To avoid contact with electrical current:
• Never install electrical wiring during an electrical storm.
• Never install the power plug in wet locations.
• Use a screwdriver and other tools with insulated handles.
FCC Radiation
Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of about eight inches (20cm) between the radiator and your
body.
This transmitter must not be co-located or operate in conjunction with any other
antenna or transmitter.
Warning