Clarion VRX653R - Manual (Page 12)

14
VRX653R
English
Owner
’s manual
2. Lock the DCP/Operation Panel at the upper
center until a click is heard.
3. Press the power button 1 to turn on the
power .
∗ The unit will not accept any key inputs for 1
second after the DCP has been reattached.
CAUTION
• The DCP can easily be damaged by
shocks. After removing it, be careful not
to drop it or subject it to strong shocks.
• If the Operation Panel is kept open, the
DCP may drop due to vibration of the car.
This results in damage to the DCP. So
close the Operation Panel or remove the
DCP to store into the case.
• The connector connecting the main unit
and the DCP is an extremely important
part. Be careful not to damage it by
pressing on it with fingernails,
screwdrivers, etc.
Note:
• If the DCP is dirty, wipe off the dirt with a soft,
dry cloth only.
The control panel can be detached to prevent
theft. When detaching the control panel, store it
in the DCP (DETACHABLE CONTROL PANEL)
case to prevent scratches.
We recommend taking the DCP with you when
leaving the car.
Removing the DCP
1. Turn the power off.
2. Deeply push in the DCP RELEASE lever 6
to release the DCP/Operation Panel.
7. DCP
3. Pull the DCP toward you and remove it.
Attaching the DCP
1. Hold the DCP/Operation Panel with its rear
side facing the main unit and, as shown in
the figure below, put the lower edge of the
panel onto the corresponding edge of the
main unit.
DCP/RALEASE lever
DCP/Operation Panel
POWER button