Clarion VRX653R - Manual (Page 35)

VRX653R
37
English
Owner
’s manual
NAVI functions
When Clarion Navigation (hereinafter referred
to as NAVI) is connected, the following
functions are enabled:
• Showing the NAVI display;
• NAVI guidance sound interruption;
• Remote operation of navigation functions by
the remote controller through the optic
sensor.
∗ While interrupting the NAVI audio signal, an
audio sound level is decreased and the NAVI
guidance sound output is mixed.
∗ NAVI guidance sound interruption is possible
even when the panel is closed, however in this
case, only the Audio Display is showed.
Setting Clarion NAVI as external
input equipment
Be sure to perform this setting after connecting
Clarion NAVI.
∗ The factory default setting is “NAVI”.
1. When the panel is open, press the ADJ
button * to show the adjustment selection
display.
2. Operate the JOYSTICK ¡ upward or
downward to select “INPUT”. A menu bar is
shown to the right to select the following
items:
● “NAVI”: Setting when Clarion NAVI
(NAX9500E, NAX943DV) is connected;
● “CCD”: Setting when Clarion CCD
camera is connected to this unit;
● “RGB”: Setting when a RGB image of
other company’s equipment is input;
● “COM”: Setting when a composite image
of other company’s equipment is input.
∗ These settings cannot be selected when the
DVD changer is connected.
3. Operate the JOYSTICK ¡ rightward or
leftward to select “NAVI”. Press ENT at the
center of the JOYSTICK ¡ to set
connection of Clarion NAVI.
NAVI Operations
NAVI operation
Changeover between NAVI display and Audio/
Visual (hereinafter referred to as AV) displays.
When the panel is open, the NVG/AV button )
has the same function as the NVG/AV button
) on the NAVI remote controller to set a
screen mode and a NAVI interruption.
Operate this button to change over between
NAVI and AV displays.
∗ When the NAVI Display/NAVI guidance sound
interruption setting (NAVI operation) is turned to
the NAVI/NAVI mode on this unit, the audio
sound level is decreased.