Clarion VRX653R - Manual (Page 46)

48
VRX653R
English
Installation and Wire
connection manual
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-
installed radio, install the main unit with the
parts and screws marked (
∗). (Figure 8)
If the vehicle is not equipped with a factory-
installed radio, obtain an installation kit to
install the main unit in the following procedure.
1. Remove the screws from both side of the
main unit. Then, at either side, lift the leaf
spring until the engaging claws are
released from the holes, and slide the
spring to the direction of arrow to remove it.
■ Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
Repeat the same for the other side to
remove the springs from the both sides.
(Figure 7)
2. Secure the mounting brackets to the
chassis as shown in Figure 8. Holes are
pre-tapped for TOYOTA and NISSAN
vehicles; modification, such as drilling new
holes, of the mounting brackets may be
required for other models.
3. Wire as shown in Section 8.
4. Secure the unit in the dashboard, and then
reassemble the dashboard and the centre
panel.
Note 1: In some cases, the centre panel may
require some modification (trimming,
filling, etc.).
Note 2: If a hook on the installation bracket
interferes with the unit, bend and flatten it
with a nipper or a similar tool.
The parts and screws with this mark
are used to install radio or included in
the installation kit.
The screws with this mark are enclosed in
this set.
(M5x6)