Futaba 4PKS-R 2.4GHz - Manual (Page 121)

121
Fu
n
c
tio
n
ARPM BRPM CRPM DRPM ERPM
ABA
BBA
CBA
DBA
EBA
ARPM BRPM CRPM DRPM ERPM
ABA
LA
BBA
CBA
DBA
EBA
ESC Link Function "MCLNK"
Page3
LAU-(LEAD ANGLE USE) ON /OFF
Same as Link software Lead Angle Use
This function is effective when TBM (Turbo Mode) is LEV1 or
LEV2 and sets whether or not lead angle is used. This setting
has priority over the TURBO MODE setting. When using in
races in which the lead angle function is inhibited by the ESC
set this function to OFF.
OFF : Lead angle function not used.
ON : Lead angle used
LA-(LEAD ANGLE) 0~59deg
Same as Link software Lead Angle
When LAU (LEAD ANGLE USE) is turned on the motor lead
angle can be set at the MC960CR. The lead angle can be set
up to 59 degrees in 1 degree increments.
A,B,C,D,E BA-(A,B,C,D,E BOOST ANGLE) 0~59deg
Same as Link software Boost Angle
A,B,C,D,E RPM-(A,B,C,D,E BOOST ANGLE RPM) 0~99990rpm
Same as Link software Boost Angle rpm
When LAU (LEAD ANGLE USE) is turned on the lead angle
versus motor speed of the 5 points A to E can be set. The lead
angle can be set up to 59 degrees in 1 degree increments.
When using in races in which the lead angle setting function is inhibited by the ESC, set LAU (LEAD
ANGLE USE) to OFF. The LAU setting has priority over TBM-(TURBO MODE). If LAU is set to
"OFF", the lead angle setting function can be turned off even if TBM is set to "LV1" or "LV2".
The MC960CR shows that the lead angle setting function is OFF ("0" timing) by blinking a LED
B (LA >"0") A (LA ="0") Lead Angle(deg) Lead Angle(deg)
rpm
The LA-(LEAD ANGLE) and A, B, C, D, E BA- (A, B, C, D, E BOOST ANGLE) relationship is shown on
the graphs below. Graph [A] shows the relationship when the same value is set at points A, B, C, D, E BA-
(A, B, C, D, E BOOST ANGLE) of [A] and [B] and the LA-(LEAD ANGLE) was set to "0" and graph [B]
shows the relationship when a value other than "0" was set at LA-(LEAD ANGLE).
As shown in the graphs, [B] is added to the A, B, C, D, E BA-(A, B, C, D, E BOOST ANGLE) set lead an-
gle and [A] is added to the LA-(LEAD ANGLE) set lead angle. For example, if "3" is set at ABA and LA of [B]
is set to "2", the actual ABA becomes 3+2=5 (deg). Since LA of [A] is "0", the actual ABA also becomes
3+0=3 (deg).
rpm