Futaba 4PKS-R 2.4GHz - Manual (Page 83)

83
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
s3ELECT
button
* b l i n k s a t t h e c u r r e n t
SETUP
4HESE
0ROGRAMMABLE
These functions allow you to apply mixing between the steering, throttle, channel 3 and
channel 4.
Two programmable mixing systems can be used. The programmable mixing 1 and pro-
grammable mixing 2 set-up screens are independent.
-When the steering or throttle channel is the master channel (channel that applies mix-
ing), trim data can be added. (Trim mode)
- The mixing mode selection. (Master mixing mode)
- The master channel mixing center point (point at which the direction changes) can be
offset. (Offset function)
Additional Functions
The movement of the master channel side will be added to the movement of the slave
channel side.
Movement of the slave channel side
When "CUT OFF", which prohibits trigger brake side operation, was set in the boat
mode (p.78), since brake side operation is shut off, when the master channel (MST) is
set to throttle, only "FWRD" side mixing is activated. "BRAK" side mixing is not acti-
vated.
When TRG-BRK was set to CUT OFF by boat mode function
0ROGRAMMABLE
(All channels)
Setup items


,%&4 
2'(4 
-34 
3,6 
-/$%

-8-$

Adjust button
TONS
BY
s3ELECT
button
3ELECTED