Futaba 4PKS-R 2.4GHz - Manual (Page 14)

14
B
e
for
e
Using
$IWHURSHQLQJWKHER[¿UVWFKHFNLIWKHFRQWHQWVFRQIRUPWRWKHIROORZLQJ7KHFRQWHQWV
depend on the set as shown below.
Set Contents
Transmitter T4PKSR
Receiver R614FS or R614FF-E
Miscellaneous
Transmitter Ni-MH battery pack HT5F1700B
*Installed in transmitter.
Receiver switch
Wheel offset adapter(APA)
Wheel adapter 32deg
Hook
Instruction manual
- If any of the set contents are missing, or you have any questions, please contact
your dealer.
 Caution
￸ When using the T4PKSR in the high speed (HIGH SPEED) mode, always use it under the follow-
ing conditions:
Servos :Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
Transmitter mode :HIGH SPEED mode (See page 46 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the trans-
mitter.
￸ When using analog servos, always switch the T4PKSR servo response to the NORMAL mode.
Transmitter mode :NORMAL mode (See page 46 for setting method.)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo.
The set cannot operate in the HIGH SPEED mode. Operation in this mode will cause trouble with the servos and other equip-
ment.
Digital servos (including BLS Series brushless servos) can also be used in the NORMAL mode.
￸ Always use only genuine Futaba transmitters, receivers, servos, ESCs (electronic speed con-
trols), Ni-MH(Ni-Cd) batteries and other optional accessories.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts speci-
fied in the instruction manual and catalog.