Futaba 4PKS-R 2.4GHz - Manual (Page 46)

46
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
s3ELECT
button
* b l i n k s a t t h e c u r r e n t
SETUP
Function
Receiver Type / Servo Response Mode "RXSYS"
Receiver Type/Servo Response Mode RXSYS
Receiver
There are two types of Futaba 2.4GHz FASST receivers for cars depending on the sys-
tem differences: C1 type and C2 type. The R603FS/FF are C1 type and the R614FS /
FF-E supplied with the 4PKSR set as standard is C2 type. For the R603FS/FF set RX
TYPE to "FASST-C1". For the R614FS/FF-E,604FS/FSE set RX TYPE to "FASST-C2".
When the receiver type and servo response are
changed and when a model with a different receiver
type and servo response has been selected, turn the
transmitter power off and on. Radio waves are out-
put by the type set at that point.
RX TYPE
FASST-C1, FASST-C2
RESPONSE
HIGH SPEED (BLS DIGI)
NORMAL (GENERAL)
(Preparation)
3ELECT
1
7RITING
0RESS
2
)N
SWITCH
Rx type / Servo response mode selection
RX TYPE / RESPONSE selection
RIGHT
Select button
TONS
HIGH SPEED or NORMAL servo response mode can be selected. However, the HIGH
SPEED mode is for Futaba digital servos (including BLS Series brushless servos) use
only. When using other servos, select the NORMAL mode. All servos, including digi-
tal servos, can be used in the NORMAL mode.
Servos
-ODE
-ODE