Futaba 4PKS-R 2.4GHz - Manual (Page 86)

86
Fu
n
c
tio
n
Four wheel steering 4WS mixing used with Corolla, etc., dual ESC mixing that controls
the front and rear motor controllers independently, gyros which allow adjustment of the
sensitivity of the Futaba car rate gyro from the transmitter, CPS-1 mixing that controls
the Futaba CPS-1 power switch, and other special mixing functions can be set by special
mixing (S-MIX) function.
3PECIAL
(Steering,Throttle,3rd,4th channel system)
3PECIAL
4WS Mixing (4WS MIXING)
This function can be used with Corolla and other 4WS
type vehicles. It is mixing that uses the 1st CH to control
the front side steering and the 3rd CH to control the rear
side steering. OFF (front side only), reverse phase, same
phase, rear side only and other 4WS types are switched by
switch.
Dual ESC Mixing (DUAL ESC)
This function is mixing that uses the 2nd CH to control the
front side motor controller and the 4th CH to control the
rear side motor controller of a Corolla or other 4WD type
vehicle. Drive is switched among front side only, rear side
only, and both front side and rear side (4WD) by switch.
Gyro Mixing (GYRO MIX)
This function is a remote gain function that uses the 3rd
CH of the transmitter to adjust the sensitivity of a Futaba
car rate gyro. It can also be used by switching the normal
mode and AVCS mode by switch. Normal mode and AVCS
mode are explained at gyro mixing (GYRO MIX).
CPS-1 Mixing (CPS MIX)
This function controls the Futaba CPS-1 channel power
switch.
Normally, when a CPS-1 unit is used to light the chassis
dress-up and other illumination (LED) the LED is con-
nected to a vacant switch channel of the connected CPS-
1 unit and the LED is turned on and off by switch while
the vehicle is running. However, when this CPS-1 mixing
(CPS-1 MIX) function is used the LED can be turned on
DQGRIIDQGDOVRÀDVKHGLQVWHSZLWKVWHHULQJDQGWKURWWOH
operation, as well as being turned on and off by switch.