Futaba 4PKS-R 2.4GHz - Manual (Page 137)

Communication port (interior left side)
Cover
DSC cord for T4PK (option)
Use the optional Adaptor cord and con-
nect both the DSC cord and the power
SW to B/C or connect the power switch
to a vacant channel of the R614FF.
137
Reference
DSC cord
When the T4PKSR transmitter and R614FF, R604FS or R603FS/FF receiver are con-
nected with the DSC cord, the servos can be operated without emitting radio waves. (DSC
function)
Part name
DSC cord for T4PK
Connection
To servos
To transmitter Communication port
DSC cord
Y-Adaptor cord
Connect the T4PKSR and receiver using the DSC cord, after turning off the T4PKSR
and receiver power switches.
Turn on the display switch of the T4PKSR and then turn on the receiver power. If this
sequence is not followed, a malfunction could occur.
You can check the servo operation without emitting radio waves.
After checking the servo operation, disconnect the DSC cord and then cycle power of
the receiver before operating the T4PKSR. If this sequence is not followed, a malfunc-
tion could occur.