Futaba 9CPS - Manual (Page 25)

25
A LOOK AT THE RADIO'S FUNCTIONS STEP BY STEP
MODEL submenu: includes three functions that manage model memory: MODEL SELECT, MODEL COPY and MODEL NAME.
Since these functions are all related, and are all basic features used with most models, they are together in the MODEL
submenu of the BASIC menu.
MODEL SELECT: This function selects which of the 12 model memories in the transmitter
(or 6 in the optional CAMPac) to set up or fly. For clarity the model's name and an image
of its type are indicated after its number. (Each model memory may be of a different
model type from the other memories.)
Note: If you are using the optional CAMPac, your choices in MODEL SELECT and MODEL
COPY will include 13-18, which are the model memories in the CAMPac. You do not
have to COPY from the CAMPac to the transmitter prior to working with that model
memory.
T9C CAMPac data
Although a CAMPac data which saved the data of a conventional T9C transmitter cannot be used calling directly, it is
possible to use it by the following method, copying to the model memories of a T9C super transmitter. When using the
CAMPac, it will be displayed, for example as "13->01 (T9C)." Press D
IAL
for 1 second in this state and the check display
of "sure?" will appear. Press D IAL again, the data of CAMPac (13) will be copied to model number"01" of the T9C super
transmitter. As for the data of a function added by T9C super, an initial value is set up at this time. Please do not forget the
check of setting data before a flight.
In addition, refer to p.15 for the conversion method from T9C to T9C super of the CAMPac data itself.
NOTE: When you choose a new model in the MODEL SELECT function, if the
new model is set to the other modulation, you must cycle the transmitter
power to change modulations. If you do not cycle the power, the modulation
type will flash on the home screen to remind you. You are still transmitting
on the other modulation until you affect this change.
GOAL: STEPS: INPUTS:
Select Model #3.
NOTE: This is one of several functions
for which the radio requires confirma-
tion to make a change.
Open BASIC menu, then open
MODEL submenu.
Choose Model #3.
Confirm your change.
Close.
for 1 second. (If ADVANCE, again.)
to 3.
for 1 second.
Confirm proper modulation of new
model memory.
Where next?
If PPM or PCM are flashing in the upper right hand corner, then the new model is
set for the other receiver type. Turn the transmitter off/on to change the modula-
tion.
NAME the model: see p. 27.
Change MODEL TYPE (aircraft, heli, glider): see p. 29.
Change modulation [FM (PPM) or PCM]: see p. 30.
Utilize servo REVERSE: see p. 31.
Adjust END POINTs: see p. 32.
Set up IDLE-DOWN and THR-CUT for throttle management: see p. 33.
Model type
• ACRO (aircraft)
• GLID (glider)
• HELI (helicopter)
FLASHING
if required to MODEL.
sure? displays.