Futaba 9CPS - Manual (Page 7)

7
A QUICK INTRODUCTION TO THE 9C super SYSTEM
Note that in the text of this manual, beginning at this point, any time we are using a feature’s specialized name or
abbreviation as seen on the screen of the 9C super, that name, feature, or abbreviation will be exactly as seen on the
radio’s screen, including capitalization and shown in a DIFFERENT TYPE STYLE for clarity. Any time we mention a
specific control on the radio itself, such as moving S
WITCH
A, K
NOB
VR(B), or the T
HROTTLE
S
TICK
, those words will be
displayed as they are here.
TRANSMITTER:
• Large graphic liquid-crystal display panel with 4 buttons and an easy set up turn-and-press Dial for quick, easy setup.
•All transmitters include all 3 aircraft types with specialized programming for each, including:
• Airplane (ACRO)
• V-tail
• ELEVON
• AIRBRAKE • Twin Aileron Servos (FLAPERON and AIL-DIFF)
• Twin Elevator Servos (AILEVATOR)
• Snap Roll (4 separate directions available)
• Helicopter (6 swashplate types, including CCPM, see page 82)(HELI)
• 3 Idle Ups
• Revo. Mixing
• Delay • Throttle and Pitch Curves per Condition
• Gyro Mixing including Separate Settings per Condition
• Governor Mixing
• Sailplane/Glider (3 wing types)(GLID)
• V-tail
• ELEVON
• START OFFSET • Twin Ailerons (FLAPERON and AIL-DIFF)
• Crow (BUTTERFLY)
• SPEED OFFSET
• BASIC menu for quick, easy set up of less complex models.
• ADVANCE menu for more complex, unique setups.
• Four electronic T
RIM
L
EVERS
for rapid yet precise trim adjustment - no remembering to “store trims” between models and
no more “bumped trims” during transport.
• IDLE- DOWN (ACRO) and THR-CUT (ACRO/HELI) (engine shut off) setups to allow precise engine control for taxi and
landings.
• 12 complete model memories with 6 more per optional CAMPac.
• New stick design with improved feel, adjustable length and tension.
• Triple rates available by setting dual rates to 3-position switches.
• Eight S WITCHES , 3 D IALS and 2 S LIDERS ; completely assignable in most applications.
• Trainer system includes the “functional” (FUNC) setting, which allows the student to use the 9C super’s mixing, helicop-
ter, and other programming functions even with a 4-channel buddy box. (Optional trainer cord required.)
• Transmits in both FM (PPM) and PCM by selecting modulation/cycling transmitter. Requires receiver of proper modula-
tion.
• Permanent memory storage via EEPROM with no backup battery to service or have fail.
• 9CA super transmitter features airplane friendly switch layout, with the trainer switch at the left hand (Mode 2), and a
notched throttle to minimize throttle changes with rudder input. Defaults to ACRO MODEL TYPE.
• 9CH super transmitter features helicopter-friendly switch layout, with idle-up and throttle hold switches at the left hand,
and a smooth, ratchet-less (unsprung) throttle for perfect hovering. Defaults to HELI(SW1) MODEL TYPE.
• Change transmitter mode from mode 2 to modes 1, 3, or 4. (See P. 15)
• Gyro Mixing
• 4 Flight Conditions (NORM/
OFFSET-1/2/3)(GLID2FL-C only)