Futaba 9CPS User Manual

Page 70

Advertising
background image

A LOOK AT THE RADIO'S GLID-SPECIFIC FUNCTIONS STEP BY STEP. Those functions which are identical to
the ACRO setups are referred directly to those pages.

MODEL TYPE: This function of the PARAMETER submenu is used to select the type of model programming to be used.

GLIDER TYPES:

Before doing anything else to set up a glider or sailplane, first you must decide which MODEL TYPE best fits your aircraft.

ACRO: for some aerobatic/slope gliders, ACRO is a better choice because of functions it offers that the GLID types do not.

ACRO provides:

S

NAP-ROLL,

A

ILEVATOR (twin elevator servo support),

AIRBRAKE (a more assignable version of BUTTERFLY).

For nitro-powered sailplanes: IDLE-DOWN, THR-CUT, THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.

But ACRO lacks programming for full-span ailerons and START and SPEED OFFSETS.

NOTE: This is one of the several functions that the radio requires confirmation to make a change.

GOAL of EXAMPLE:

STEPS:

INPUTS:

CH1

CH2

CH4

CH5

CH6

CH7

Glider2FLAP/2FL-C Configuration

CH1

CH2

CH4

CH6

CH6

CH7

Glider1FLAP Configuration

70

Change model 1 is MODEL TYPE
to GLID1FLAP.

.

NOTE: This is one of the several
functions that the radio requires
confirmation to make a change.

Where next?

Confirm you are currently using the
proper model memory. (Ex: 1)

Open PARAMETER submenu.

Change the MODEL TYPE.
Confirm the change.

Close.

On home screen, check model name
and number on top left.
If it is not the correct model (Ex: 1),
use MODEL SELECT, p. 25.

for 1 second.

(If Advance menu again.)

to 2nd page of menu.

1 step to PARAMETER.

to TYPE.

to GLID1FLAP

for one second.

sure? Confirmation displays.

to confirm.

Remember: Now that you changed MODEL TYPE, the model memory is
almost completely reset. Only the modulation remains intact.
NAME the model: p. 27.
Change the receiver modulation from FM (PPM) to PCM or vice versa: see p. 30.
Utilize servo REVERSE: see p. 31.
Adjust servo travel with END POINT: see p. 32.
Set up dual/triple rates and exponential (D/R,EXP): see p. 35.

GLID2FLAP/GLID2FL-C: The GLID2FLAP/GLID2FL-C MODEL TYPE supports dual flap servos that can also act as
ailerons, creating full-span ailerons and flaps. Additional flight conditions available (GLID2FL-C only). These
flight conditions contain different offset trims and aileron differentials to make the sailplane perform certain
maneuvers more easily.

GLID1FLAP: The GLID1FLAP MODEL TYPE is intended for sailplanes with one or two aileron servos (or none), and

a single flap servo (or two connected with a y-connector). This TYPE is meant to be a very simplistic version to set up
a basic glider without a lot of added features. Full-span ailerons are not possible in this MODEL TYPE.




Advertising
This manual is related to the following products: