Futaba 9CPS User Manual
Page 99
GOAL of EXAMPLE:
STEPS:
INPUTS:
9
9
Set up a GV1 governor to use both
channels into the receiver and switch
between the governor settings
automatically when changing conditions.
Consider setting the battery FailSafe
settings and other helpful functions on
the GV-1 itself.
Where next?
Open and activate the GOVERNOR
function.
Optional: change cut-off channel to
channel 8 and assign switch and
direction for on/off (channel 8).
Optional: change switch assignment
to select governor settings. Ex: select
switch that selects the conditions.
Adjust governor speed settings per
switch position or condition as needed.
(Ex: defaults are fine.) Allows head
speed adjustment from transmitter.
Close the function.
for 1 second.
(If basic, again.)
to GOVERNOR.
to ACT.
to CH8.
to - if opposite switch
direction is desired.
to desired S
WITCH
.
to SW.
to G.
to each S
WITCH
position.
or as
needed.
to next S
WITCH
position. Repeat.
GYRO: see p. 95.
Adjust FailSafe (F/S) settings (p. 43).
Adjust idle-up 3 collective pitch curve for same rates of climb upright/inverted.
See p. 90.
Adjust elevator/aileron response to fit your flying style: see D/R,EXP and END
POINT/SWASH AFR: pp. 35, 32, 84.