Futaba 9CPS - Manual (Page 4)

4
Application, Export, and Modification
1. This product may be used for model airplane or surface (boat, car, robot) use, if on the correct frequency. It is not
intended for use in any application other than the control of models for hobby and recreational purposes. The product is
subject to regulations of the Ministry of Radio/Telecommunications and is restricted under Japanese law to such purposes.
2. Exportation precautions:
(a) When this product is exported from the country of manufacture, its use is to be approved by the laws governing the
country of destination which govern devices that emit radio frequencies. If this product is then re-exported to other coun-
tries, it may be subject to restrictions on such export. Prior approval of the appropriate government authorities may be
required. If you have purchased this product from an exporter outside your country, and not the authorized Futaba distribu-
tor in your country, please contact the seller immediately to determine if such export regulations have been met.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regulations, and an applica-
tion for export approval must be submitted. In the US, use of 72MHz (aircraft only), 75MHz (ground models only) and
27MHz (both) frequency bands are strictly regulated by the FCC. This equipment must not be utilized to operate equip-
ment other than radio controlled models. Similarly, other frequencies (except 50MHz, for HAM operators) must not be
used to operate models.
3. Modification, adjustment, and replacement of parts: Futaba is not responsible for unauthorized modification, adjust-
ment, and replacement of parts on this product. Any such changes may void the warranty.
The Following Statement Applies to the Receiver (for U.S.A.)
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable operation.
The RBRC™ SEAL on the nickel-cadmium battery contained in Futaba products indicates that Futaba
Corporation of America is voluntarily participating in an industry-wide program to collect and recycle
these batteries at the end of their useful lives, when taken out of service within the United States. The
RBRC™ program provides a convenient alternative to placing used nickel-cadmium batteries into the
trash or municipal waste system, which is illegal in some areas.
(for USA)
You may contact your local recycling center for information on where to return the spent battery. Please call 1-800-8-
BATTERY for information on Ni-Cd battery recycling in your area. Futaba Corporation of America’s involvement in this
program is part of its commitment to protecting our environment and conserving natural resources.
NOTE: Our instruction manuals encourage our customers to return spent batteries to a local recycling center in order to
keep a healthy environment.
RBRC is a trademark of the Rechargeable Battery Recycling Corporation.