Futaba 9CPS User Manual

Page 53

Advertising
background image

GOAL of EXAMPLE:

STEPS:

INPUTS:

53

Activate SNAP-ROLL. Adjust elevator
travel to 55%, rudder travel to 120%in
the right/up snap. Activate SAFE-MOD
so snaps can not be performed when
gear is down.

Adjust rudder travel in the left/down
snap to 105%.

(Note: using negative percents can
change any of the 4 snapsí directions.
For example, change snap 1 to
ìdownî by changing the elevator
percent to -
100%.)

Where next?

Open the SNAP-ROLL function.

Activate the function.

Adjust the travels as needed. (Ex:
elevator to 55%, rudder to 120%.)

Optional: Activate

SAFE-MOD

. [Ex:

ON

when S

WITCH

E (9CA) or G (9CH) is

down,

meaning

snap

function

is

deactivated when that switch is in the
down position.]

Optional: Assign switches to up/down and
left/right. (Ex: Change to the left/down
snap and adjust rudder to
105%.)

Close menu.

for 1 second.

(If basic,

again.)

to SNAP-ROLL.

to OFF or ON.

to 55%.

to 120%.

E or G up.

to

ON.

snap switch.

Notice mix reading is still OFF.

E or G down.

Notice MIX reading changes to ON.

to A.

to B.

A down B down.

Repeat steps above to set percentages.

Set up programmable mixes: see p. 54.
View additional setups on the internet:

www.futaba-rc.com\faq\faq-9c.html.

Advertising
This manual is related to the following products: