Futaba 9CPS User Manual

Page 92

Advertising
background image

DELAY: The Delay function provides a smooth transition between the trim positions whenever OFFSET, REVO. MIXING, or
THROTTLE HOLD functions are turned on and off.

GOAL of EXAMPLE:

STEPS:

INPUTS:

92

Set up a delay on all 3 channels to ease
the transition from one flight condition
to another so there are no "hard jumps."

Where next?

Open the DELAY function.

Adjust AIL response as needed. (Ex:
aileron to +8%.)

Repeat for other channels.

Close menus and confirm slowed
transitions.

for 1 second.

(If basic, again.)

to DELAY.

to +8%.

to ELE. Repeat step above.

E (9CH) or G (9CA) from

NORMAL to IDL2. Check that servos
move gradually to new positions.

THR-HOLD: see p. 88.

Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
(TH-CURVE, PIT-CURVE, REVO. MIXING for idle-ups: see p. 90.

Adjustability:

• Separate delay times are available for aileron, elevator, rudder, throttle, and pitch.

• With a 50% delay setting, the servo takes about a half-second to move to its new position...quite a long time.

• In general, delays of approximately 10-15% are sufficient.

Advertising
This manual is related to the following products: